Description

Characteristics

Brand new and of high quality.

Materials: thermoplastic copolymer.

Color: bright.

Size (app): 6.3m X 5cm-2.48inch x 1.97inch.

Package included

1/2/3/4/5/6Pairs Dental Grinding Blocks

Self-made heat-hardening forms of dental prosthetic accessories

Made of imported medical food grade silicone, it is safe, non-toxic, and has no side effects.

Method for making dental brackets:

1.Week the dental support in warm water at about 70 degrees Celsius for 10-15 seconds to soften it.Make sure you don't use hot water that's too hot at 90 degrees Celsius because this can cause the dental support to break into a ball.When you see the edge of the dental support wrinkling, you can remove it;

2.Put the softened dental support in your mouth, apply it to the gums, suck and remove the air between the dental support and the gums, and use your hands to firmly press back and forth on the joint surface between the dental support and the gums to make it fit closely with the gums.The dental support made in this way is suitable for the shape of your teeth.Watch out for the speed, but don't bite hard;

3.After pressing it with your hand, hold it for about half a minute and at this point you can remove the already formed dental tray.

4.Along the gingival line (the line between the teeth and the gums) stamped on the already formed tooth holder, use scissors to cut off the excess material, and trimmed the handle at the same time.At this point, the dental holder is complete.Cutting off the part above the gum line can ensure that the gel only contacts the teeth to prevent gum damage.

Be careful:

1.If the dental brace is not made properly in one go, the second design can be revised until satisfactory.

2. before and after using the dental support, rinse it with clean water;

3.The replacement time for dental braces is 3-4 months, the same as for toothbrushes.

The first time you wear a dental brace, you will definitely feel uncomfortable.Stick with it a few more times and get used to it.

The method of making is as follows

1.Artificial denture wear exercise: place the tray over the upper jaw, suction method using air release between the denture and gum, allowing the denture to wrap around the entire surface of the tooth.(Practice twice, which is an important process to make the bottom drawer the same way to practice)

2.Soaking tub: The 80°C water in the ground tub, water depth to be able to handle removed after submerging the tray and left in the water outside is suitable, submerged the prosthesis in water for 5 to 7 seconds.(Artificial teeth at this moment very soft, so the immersion time not too long, soft artificial teeth made in extension, start to deform slightly fitting)

3.Make mouthpiece: mouthpiece carefully and quickly made on the dental gum, keep sucking step 1.Finger-pressed prosthetic tooth-binding surface, which makes it thinner, while the upper tight tongue and teeth bite the inner surface of the prosthesis.(Sneller, be careful not to bite hard.Mouthpiece a little hot, but it won't cause any damage.

They said: Remove the finger that's stuck after 10-15 seconds, rinse with water. Use scissors to cut along the gum line (that line between your teeth and gums) to remove excess material and finally cut off the handle. (Trim above the gum area, it can only make contact with the tooth gel, avoid stimulating the gums)